I was playing with my Flower Shoppe cricut cartridge again today and decided to share with you step by step directions I created the flower for this thank you card
I cut three set of flowers from Flower Shoppe at 3”, 2 ½ and 2”
Take scissors and cut notches into each pedal as seen here
Ink each pedal
Take a stylus and rub it over the entire flower pedal by moving the stylist in a circular motion
Pinch the middle of each pedal as seen here
Curl the edges of each side of the pedal back as seen here then apply glue to each tab and glue
Play with each pedal until it has the look you want. Place glue in the center of each flower and stack alternating the pedals as you go. Drop in some pearls or any other embellishment. Add stickles around the edges of each pedal.
I hope you found this easy to follow and make your own soon.